Splicing Kit, Imperial & Metric

Keep in a cool dry place
Splicing kit for on the job repairs with rapid set adhesive. This Splicing Kit will enable you to construct rings to your custom requirements. There are no special skills required – just follow instructions. This kit contains everything you need to produce a perfect O`Ring.

Contents:
One razor blade, one splicing and cutting tool, one adhesive for rubber use and popular size of O`Ring cord for below two different kits.

1.How to cut cord
If the O`Ring diameter is known just multiply by 3.14 to obtain the length. If the diameter is not known then place the cord in the O`Ring groove or around the shaft at the seal location and mark off the cord. Add ½” and cut off. Mark the final cut by inserting cord into cut cutting and splicing tool.

2.How to apply adhesive
Remove the cap and flick the end of the tube with your finger to remove the liquid from the tip. Make a small hole in the tip with the pin. Apply the adhesive to only one of the surfaces to be bonded. See that the tip actually contacts the surface. Only a fraction of a drop is required. Caution: more adhesive will make a poor bond.

3. Joining the ends
For proper aligning quickly place the treated surface into the correct “U” groove on the open side of the jig. Insert the untreated end into the “U” groove and slide it towards to meet the treated surface. Make firm contact and hold in position for one half minute with slight finger pressure. Caution: be certain, not twist cord material before bonding.

Enquire Now!